KCD1 RED LIGHT PANEL MOUNT ROCKER SWITCH 3PIN 6A

KCD1 RED LIGHT PANEL MOUNT ROCKER SWITCH 3PIN 6A

The illuminated rocker key is used to detect whether the key is on or off and also to find the key faster.

In this switch, one of the wires carrying the power is connected to the electrical equipment that intends to turn it on or off by means of pins of the same color, and the other wire is connected to the golden base of this switch, and of course directly to the other terminal of the equipment. Electrical connection

Tolerable voltage: 250 volts

Tolerable current: 6 amps

Body material of heat-resistant bakelite due to the passage of electric current

Bakelite: Insulating material against heat and electric current, which is actually a type of polymer combined with resin that is made with a filler such as asbestos to increase its strength.

The blades are made of copper, which is plated, and the two ends of the contacts inside the key are made of high-quality platinum

To determine the quality of the body, you can heat the body with a lighter to compare its strength with similar samples.

To determine if the blades are real copper, you can use a magnet that if it is copper will not absorb the magnet or cut the blade with a small cutter or copper paint at the lowest price of the blades (near the key body) and when plating this part plating Does not take copper check the color left
You must open the switch to detect whether the contacts are platinum. In low quality samples, the contacts are made with a pin and sometimes it is convex, but platinum samples make the contacts with a separate piece made of materials such as copper, nickel, brass and silver, which is known in the market as platinum. And both sides of these contacts must have platinum